Simulador de cortacésped con cable perimetral

Simulador visual del cortacésped autónomo: sigue el cable perimetral, rebota en colisiones, gira de forma aleatoria y marca la zona cortada con el tiempo.

Perimeter wire Cut area Charging base Robot
Flow
  1. Start at the charging base on the wire.
  2. Follow the wire backwards for half of the perimeter.
  3. Move inside the perimeter and begin cutting.
  4. Advance forward (straight or spiral).
  5. If next step crosses the wire, bounce back and turn.
  6. Mark cells under the cutting radius.

The mower starts at the charging base, which sits halfway along the perimeter wire. First it follows the wire backwards for half of the perimeter length by default, then it moves into the lawn and begins cutting. This helps it “hug” the boundary before it starts covering the interior.

Straight mode is efficient for open lawns but can leave narrow strips if the turns line up poorly. Spiral mode fills small patches nicely and smooths out missed gaps, but it can overwork the same area if the spiral is too tight. Try switching modes and watch how the coverage pattern changes.

Perimeter

You can draw your own perimeter wire here.